Product : Charge Controllers (CA-Series)
Solar Charge Controllers
- Electronically regulated charging regime: Boost and float charge
- Deep discharge protection
- PWM series regulation, no panel short circuit
- Integrated temperature compensation
- Reverse blocking Mosfet
- Fully electronically protected: panel surge voltage, Wrong polarity at panel or battery, Overload and short circuit at load
- 4 LED indications: Charge status,SOC, LVD, Overload/Short Circuit
- Common positive allows grounding
The new version of CA solar charge controller series is especially designed for small solar systems with the need of a low battery disconnect feature.
Main differences to the preceding CA series: The regulation circuit provides now series regulation to prevent single cell overheat problems of short-circuited solar panels. The terminal section has been replaced by a rugged, well profane 16mm2 terminal block.
The melting fuse of the predecessor has been replaced by a fully electronically protected circuit.
2 LEDs and 1 Duo-LED to display charging in progress, battery SOC, load disconnect and overload status.
Leisure and rural electrification systems are the typical applications for this product. It is a perfect solution for cost-sensitive systems which require state-of- the-art system management.
The compact case is now similar to the well-known CML series.
| TYPE |
CA06 |
CA08 |
CA10 |
CA14 |
| Nominal voltage |
12V |
12V |
12V |
12V |
| Temp. Compensation |
-3mV/cell*K |
-3mV/cell*K |
-3mV/cell*K |
-3mV/cell*K |
| Max. module current |
5A |
8A |
10A |
14A |
| Max. load current |
6A |
8A |
10A |
14A |
| Dimensions |
80 x 100 x 32 mm |
| Weight |
180gr |
| Max. Wire size |
16mm2 (AWG#6) |
| Self consumption |
4mA |
| Temperature range |
-40 to +50 °C |
Type of protection
|
IP22 |
|